Go back

ProtectGuard® MG

Water/oil repellent, soiling and graffiti protection for very low porous, polished or crystallized materials

ProtectGuard® MG is a very concentrated in active material and extremely effective in protecting porous and slightly porous material. It prevents the ingress of water, oil, grease, graffiti, weak acids (fruit juice, condiments) and all types of soiling.

ProtectGuard® MG is a permanent, non-film forming impregnation product, the material remains permeable to air and water vapour. Colourless after application, it does not change the appearance or the nature of the treated material. ProtectGuard® MG is also fully resistant to UV rays and does not yellow over time.

Sales contact
  • Beading effect
  • 10 years guarantee
  • Floors, facades
  • Coverage (1L = 20m2)
Advantages
  • High-performance protection against water, oil and stains
  • Abrasion resistant
  • Permanent anti-graffiti property
  • Food contact compliant
  • Does not form a film, lets the material breathe
  • Invisible: does not change colour
  • UV and frost resistant
  • Slows down ageing and makes maintenance easier
USE
  • Slightly and very low porosity materials: marble, granite, sandstone, slate, polished materials, concrete, etc.
  • Floors and facades
  • New or old
  • Internal and external
  • Recommended for patios, pedestrian areas, living rooms, facades, stairs, etc.
Back to the list
Advantages
  • High-performance protection against water, oil and stains
  • Abrasion resistant
  • Permanent anti-graffiti property
  • Food contact compliant
  • Does not form a film, lets the material breathe
  • Invisible: does not change colour
  • UV and frost resistant
  • Slows down ageing and makes maintenance easier
USE
  • Slightly and very low porosity materials: marble, granite, sandstone, slate, polished materials, concrete, etc.
  • Floors and facades
  • New or old
  • Internal and external
  • Recommended for patios, pedestrian areas, living rooms, facades, stairs, etc.
Application
Application tools
Packaging
Technical documents

Surface preparation :

  • 1
    Apply the product to a clean, dust-free, grease-free and dry surface.
  • 2
    To remove grease stains, use Guard Cleaner® Maintenance.
  • 3
    Rinse carefully until the surface is free of any trace of cleaner.

Application :

  • Use the product in its pure form: do not dilute it.
  • Shake the packaging well before use and carry out a preliminary test.
  • Apply the product in one go. Let it soak in and let the product dry (10 to 60 minutes depending on the porosity and temperature of the material).
  • Do not overload the material, remove any excess with a soft cloth dabbing the material before drying the product.
  • The surface dries in 1 hour.
  • The surface must be protected from traffic and liquids (rain, grease, etc.) for 24 hours
  • On very-low porosity or polished materials, the surface must be polished with a microfibre cloth after application.
  • Optimum efficiency of the product is obtained after 48 hours drying.

For further information, refer to the data sheet and safety sheet.

  •

    Apply with a cloth, a brush or flat microfibre brush.

  • 5L

  • 25L

  •

    Technical data sheet

  •

    Safety data sheet

A project ? Contact a sales representative

Our sales teams support you throughout your project, from the choice of products to their implementation.
Sales contact